First we need to Check: Place the drone at a suitable take-off point, unfold the arms of the airplane, install the GPS, and check whether all the screws are tightened.
1. Next Calibration: Turn on the remote control, connect drone battery. connect the receiver with Bluetooth, then start calibration according to indications on APP.(Calibrate accelerometer, place the drone in level, click accelerometer to start, wait 3 to 5 seconds until calibration finish as indicated by the LED. after successful, calibrate compass, Rotate the aircraft horizontally until the aircraft status indicator is steady green. Then turn the aircraft nose down and rotate again until the indicator light flashes alternately in red, green and yellow, and the calibration is completed. .) After successful, install the blades to ensure that the blades and the motors rotate in the same direction. Pour liquid into the tank, turn on the water pump and nozzle, and vent the air.
2. Take off: in GPS mode, Unlock the motor, take off the drone
Switch SA to GPS mode, fly the drone to A point, switch SD to middle position. A point has been set successfully. Fly the drone to B point. Switch SD to bottom position, B point has been set successfully. Switch SA to operation mode. Toggle the right sticker to select the direction,left or right. Then the drone start operation. When you need to stop the operation. Switch S A to GPS mode, if there’s no any obstacles, just click “one button to home” in the app or switch SB to bottom position, the drone will get home slowly. When the plane close to the ground two or three meters, We recommend landing manually to make sure stability and safety. just switch SB to up position. The drone will stop “ready to home”. you can control the drone to land. When the drone lands on the ground, push the throttle down and hold three seconds until propellers all stopped.
if land is not regular, you can design the spraying routes.
Switch S A to GPS mode, click the third icon on the left screen, click New to build a new task with a name. Then click Drone point, add area, fly the aircraft to the corresponding location one, click common, then number one point marked successfully. Fly the drone to position two, click common, then number two point marked successfully. Record number three point, number four point in sequence . adjust the swath, save the route, Switch S A to operation mode. swipe right. The drone start operation. If there’s an obstacle inside the area, use the same way to mark the points of obstacle. The drone will avoid the obstacle automatically in spraying.
When battery is low voltage or tank is empty, the drone would alarm you by lightening and hovering. switch SA to GPS mode. The drone will Exit operation. The point which drone hovering is a break point. APP will record it. You can let drone at home manually or click “one button to home” in the app or switch SB to bottom position. After you change battery and fill pesticides. you want to resume the operation. Just switch SA to operation mode. The drone will get back to break point and resume to spray.
Thank you for choosing ASTA Agricultural drones. We have a variety of drones with different payloads, and will also create more possibilities in the field of industry applications. We have provided services to many countries around the world. Looking forward to further cooperation with you.
http://www.youtube.com/watch?v=t_ttzWA8ynM
